Structural Characteristics of Sn(SexTe1‒x) Thin Films Fabricated from Bulk Alloys via Vacuum Evaporation
Main Article Content
Abstract
Tin selenide-telluride (Sn[SexTe1‒x]) alloys are promising candidates for next-generation solar cell applications; however, their structural characteristics are still not fully understood. This study investigates the effect of selenium (Se) and tellurium (Te) composition on the structural properties of bulk-derived Sn(SexTe1‒x) thin films with x = 0.0, 0.2, 0.4, 0.6, 0.8 and 1.0. The bulk alloys were synthesised using the Bridgman method and subsequently employed as source materials for the thin-film fabrication via vacuum evaporation. Energy-dispersive X-ray spectroscopy analysis revealed increasing deviations from ideal stoichiometry with higher Se content, particularly in the bulk samples. In contrast, the thin films exhibited compositions closer to the intended Se-to-Te ratios, attributed to more controlled deposition and reduced segregation during film growth. Scanning electron microscopy analysis showed that bulk samples exhibited significant grain structure variation with increasing Se content, whereas thin films displayed a more uniform morphology—transitioning from granular to nanostructured features. X-ray diffraction analysis revealed a structural transition from a cubic phase (SnTe, x = 0.0) to an orthorhombic phase at higher Se concentrations (x ≥ 0.6), accompanied by corresponding changes in lattice parameters. At x = 1.0 (SnSe), both the bulk and thin-film samples exhibited identical lattice parameters (a = 11.470 Å, b = 4.152 Å and c = 4.439 Å), confirming the formation of a pure orthorhombic phase. These findings emphasise the importance of compositional control in tuning the structural phases of Sn(SexTe1‒x) alloys and demonstrate the viability of fabricating high-quality thin films from bulk-derived source materials. The successful transfer of structural integrity from bulk to thin-film form opens new avenues for optimising these materials for photovoltaic device applications.
Article Details
References
Ramkumar, M. S. et al. (2022). Semiconductor materials for solar PV technology and challenges towards electrical engineering. Adv. Mater. Sci. Eng., 2022(1), 7272489. https://doi.org/10.1155/2022/7272489
Sohail, M. et al. (2024). Recent developments, advances and strategies in heterogeneous photocatalysts for water splitting. Nanoscale Adv., 6(5), 1286‒1330. https://doi.org/10.1039/D3NA00442B
Ahmad, I. et al. (2023). Semiconductor photocatalysts: A critical review highlighting the various strategies to boost the photocatalytic performances for diverse applications. Adv. Colloid Interface Sci., 311, 102830. https://doi.org/10.1016/j.cis.2022.102830
Benda, V. (2020). Photovoltaics, including new technologies (thin film) and a discussion on module efficiency. In Letcher, T. M. (Ed.). Future energy: improved, sustainable, and clean options for our planet. Amsterdam: Elsevier, 375–412.
Shen, L., Li, Z. & Ma, T. (2020). Analysis of the power loss and quantification of the energy distribution in PV module. Appl. Energy, 260, 114333. https://doi.org/10.1016/j.apenergy.2019.114333
Raksa, P. et al. (2025). Nanocrystalline lanthanum-doped bismuth ferrite as a perovskite photosensitizer: Morphological, structural, optical, photovoltaic properties, and DFT calculations. Mater. Lett., 386, 138217. https://doi.org/10.1016/j.matlet.2025.138217
Hamady, S. O. S. et al. (2019). Development of novel thin film solar cells: Design and numerical optimisation. J. Phys. Sci., 30(2), 199‒205. https://doi.org/10.21315/jps2019.30.s2.17
Yadav, R. K. et al. (2022). A qualitative study of SnSe thin film solar cells using scaps 1D and comparison with experimental results: A pathway towards 22.69% efficiency. Sol. Energy Mater. Sol. Cells, 244, 111835. https://doi.org/10.1016/j.solmat.2022.111835
Li, Z. et al. (2020). Effect of film thickness and evaporation rate on co-evaporated SnSe thin films for photovoltaic applications. RSC Adv., 10(28), 16749‒16755. https://doi.org/10.1039/D0RA01749C
Gu, S. et al. (2017). Self-driven, broadband and ultrafast photovoltaic detectors based on topological crystalline insulator SnTe/Si heterostructures. J. Mater. Chem. A, 5(22), 11171‒11178. https://doi.org/10.1039/C7TA02222K
Feng, D. et al. (2017). Hydrothermal synthesis of SnQ (Q = Te, Se, S) and their thermoelectric properties. Nanotechnol., 28(45), 455707. http://doi.org/10.1088/1361-6528/aa8b29
Shi, W. et al. (2018). Tin selenide (SnSe): Growth, properties, and applications. Adv. Sci., 5(4), 1700602. https://doi.org/10.1002/advs.201700602
Patel, K. et al. (2020). Orthorhombic SnSe nanocrystals for visible-light photodetectors. ACS Appl. Nano Mater., 3(11), 11143‒11151. https://doi.org/10.1021/acsanm.0c02301
Jagani, H. S. et al. (2022). Self-powered anisotropic photo-responsive properties of tin mono-selenide (SnSe) photodetector. Opt. Mater., 132, 112756. https://doi.org/10.1016/j.optmat.2022.112756
Patel, K. et al. (2024). X-ray diffraction analysis of orthorhombic SnSe nanoparticles by Williamson–hall, Halder–Wagner and size–strain plot methods. Chem. Phys. Impact, 8, 100547. https://doi.org/10.1016/j.chphi.2024.100547
Ariswan, A., Prasetyowati, R. & Sutrisno, H. (2018). Physicochemical properties of Sn(Sx,Te1-x) solid solutions of both massive materials and thin films. Chalcogenide Lett., 15(3), 173‒180.
Jamwal, G. et al. (2023). Structural, electronic and thermoelectric properties of SnTe with dilute co-doping of Ag and Cu. J. Alloys Compd., 954, 170182. https://doi.org/10.1016/j.jallcom.2023.170182
Mandal, P. et al. (2020). Visible-light active electrochemically deposited tin selenide thin films: synthesis, characterization and photocatalytic activity. J. Mater. Sci.: Mater. Electron., 31, 4708‒4718. https://doi.org/10.1007/s10854-020-03027-0
Li, W. et al. (2014). Non-monotonic pressure dependence of band gap in SnTe. Chem. Phys. Lett., 616, 196‒198. https://doi.org/10.1016/j.cplett.2014.10.050
Ariswan, Sutrisno, H. & Prasetyawati, R. (2017). Crystal structure, optical, and electrical properties of SnSe and SnS semiconductor thin films prepared by vacuum evaporation techniques for solar cell applications. In IOP Conference Series: Materials Science and Engineering (012042). https://doi.org/10.1088/1757-899X/202/1/012042
Tan, C. et al. (2020). Evaporated SexTe1-x thin films with tunable bandgaps for short-wave infrared photodetectors. Adv. Mater., 32(38), 2001329. https://doi.org/10.1002/adma.202001329
Ghazala, M. S. A. et al. (2020). Fabrication of nanocrystalline silicon thin films utilized for optoelectronic devices prepared by thermal vacuum evaporation. ACS Omega, 5(42), 27633‒27644. https://doi.org/10.1021/acsomega.0c04206
Christy, D. S., Sahaya, S. X. & Mahadevan, C. K. (2022). Study of physico-chemical properties and growth dimension augmentation of barium succinate single crystals grown by slow evaporation technique. J. Phys. Sci., 33(1), 24‒29. https://doi.org/10.21315/jps2022.33.1.3
Fernandes, P. A. et al. (2013). Thermodynamic pathway for the formation of SnSe and SnSe₂ polycrystalline thin films by selenization of metal precursors. Cryst. Eng. Comm., 15(47), 10278‒10286. https://doi.org/10.1039/C3CE41537F